Questions & Answers for: Mitsubishi Eclipse bracket

belts my power steering belt is making a high pitched sound and im missing a bracket that looks like and adjustment. I think that the missing peice is whats causing the sound but i dont know what that

...simply start by putting the outter hose on first and bolting it down if needed.. there should be a bracket, then install the mass air flow sensor, and then the upper hose to the throttle body..... ...

...ECLIPSE take the front wheels off,remove the 2 bolts holding the caliper to the caliper mounting bracket and then remove the caliper and then take the old pads out while you remember which ones ...

How to install a front license plate bracket on a 2001 Mitsubishi Eclipse. if it is a factory bracket there are 4 dimples on the middle of the bumper,you have to drill 1/2 in holes to install 4 ...

Location of the fuel reay switch The fuel pump relay for the 2.0 non turbo is mounted on a bracket at the left rear of the engine compartment. On the 2.0&2.4 turbo it's located behind the center ...

I have a 1998 Mitsubishi Eclipse w/ 2.0; I am going to change the water pump, took off the bracket that holds the engine to chassis support in front of timing cover. The bracket will not come off ...

...switch electrical connector. Using a chisel and screwdriver, back out bolts at steering lock bracket. Insert key into steering lock cylinder, and turn to ACC position. Using a small Phillips ...

...drive belt. Remove the alternator upper and lower mounting bolts. Remove the alternator support bracket mounting bolts. Remove the alternator support bracket from the vehicle. Disconnect the ...

...up a bit. Get a big drain pan. Remove the bolts to the transmission pan. Now you will see a little bracket holding the filter. Go ahead and remove the screws holding it in place. Now remove the ...

What is the correct torque for the front caliper mounting bracket bolt and front caliper guiding pin? 74 ft-lbs (plus or minus 7 ft-lbs)