...at low speeds check all bolts that hold the bags they come lose make all type of noise and the brackets brake too check muffler bracket and all clamps to be tight hope this ...
Question about 2008 FLHX Street Glide
...a way to improve this further? I have a 2007 street glid eand have been through 2 sets of fairing brackets. it started with around 500 miles on the bike. very bad design, I had the factory bracket ...
exhaust bracket behind rear cylinder on 2007 FLHX There is an exhaust bracket directly behind the rear cylinder under the seat. (its the first bracket behind the "Y" on the cross over.) The bracket ...
...the pads on your bike, look at the caliper and you'll see two bolts that hold it into the caliper bracket. Remove these two bolts. Rock the caliper in towards the wheel and back out a few times to ...
...the way of accessing the brake caliper. Remove the two bolts that hold the caliper into the caliper bracket. Lift the caliper off of the bracket. Note the way the pads and the anti-rattle stuff is ...
Is the rear caliper bracket just held by the axle? does the other end just set on the swing arm or does it hook to something It just sets on the rear swing arm. Usually, it has a "C" type deal that ...
Question about 2008 FLHX Street Glide
...on my 2007 street glide Hi Anonymous, remove and reinstall bolts one at a time. Lower fork stem bracket torque 30-35 ft lbs. upper fork stem bracket 23-28 ft lbs. Good ...
Question about 2008 FLHX Street Glide
...front and rear mounting screws with captive washers, remove the Keps nut from the stud of the bracket tab and remove the exhaust support bracket, pull back the rubber boot and remove the hex
...front and rear mounting screws with captive washers, remove the Keps nut from the stud of the bracket tab and remove the exhaust support bracket, pull back the rubber boot and remove the hex
Question about 2007 FLHX Street Glide
...the Maxi fuse. Remove the left pannier, then the Maxi fuse. Pull fuse block from tabs on mounting bracket. Tabs on bracket fit into slots on each side of fuse block cover. Remove the fuse block ...
Usually answered in minutes!
644 Questions
133 Questions
72 Questions
82 Questions
68 Questions