...brake booster was told i needed to replace my brake booster on my 96 2.3 ford ranger how so i so that? go to the master cylinder and remove it from the booster, disconnect the vacuum line from the ...
...Brake Booster. On the bottom, below the Master Cyl, is it dry or does it look like there is some leakage? If it is wet, and all the above check out OK, then I would replace the Master Cylinder. Be ...
...brake booster on 1988 ford ranger REMOVAL & INSTALLATION NOTE: Make sure that the booster rubber reaction disc is properly installed if the master cylinder push rod is removed or accidentally ...
Question about 1984 Ranger
...b the pcv valve on the valve cover or the hose going to the brake booster. Take the hose off the brake booster and plug it. then start the engine. It might also b the base gasket under the
install master cylinder on 1993 ford ranger master cylinder will not seperate from the brake booster Check that the master cylinder push rod is disconnected from the brake petal under the dashboard.
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions