Questions & Answers for: broken lid

...to shut the door completely or the lid switch could have been broken. or the plastic that should press the lid switch could have been broken also. it is attached to the door i hope i was able to

...lid is broken in one corner and won't stay closed - can I get a new lid? Thanks Greg you could but the cost and time would not be worth it,just find you some gray electrical tape,works wonders,but ...

broken so the lid no longer stays open. Very dangerous. Any assistance? Thanks The trunk lid torsion bar has broken so the lid no longer stays open. Very dangerous. Any assistance? Thanks Replace with

...Lid switch broken. It may need to be replaced. - Motor broken. QUite expensive repair, the motor needs to be replaced. - Timer broken. Check the lid is correctly closed, perhaps the lid switch is ...

broken lid slot on my tefel actifry lid the clear plastic lid has two slots at either side to help lock one of the side plasitc slots is broken can I purchase lid Thank You M.M. Rigg Hi there. You can

...broken lid switch. The lid switch is mid center side of the rim of the lid opening when looking at the washer from the front.ina lot of case by looking in that area ya can see where its broken and ...

broken clip on rear lid N70 broken clip on rear lid-need lid. is your lid catch or hinge broken

...broken. To find the lid switch, look for a pin on the lid that goes through a hole in the top of the machine when the lid is closed. The lid switch actuator is under this hole. If you can't see ...

...lid switch does not have continuity, replace it. Parts Cause 2Motor Coupling The motor coupling connects the motor to the washing machine transmission. If the washer is overloaded, the motor coupling ...

broken lid switch, without an exact model number its hard to be sure. If you normally have to close the lid for the washer to drain and spin that is probably the part that is broken. Pretty common for