Questions & Answers for: Buell X1 lightning broken spark plug

Question about 2001 X1 lightning

1 Answer

01 X1 lightning will not start my x1 lightning will not start it turns over n every like 5 seconds it will start but only idle for about 3 seconds..acting like its not getting gas...i pulled the line ...

Ad

Question about 2000 X1 lightning

1 Answer

broken gearbox I have a selector drum and fork that is damaged and I don't seem to find repracement parts. I have a buell X1 lightning 2001. I would like to buy new parts or good second hand ones. I ...

Ad

2002 x1 no spark at plugs, have checked battery earth and changed the two small relays in the fuse box, when i turn the key on and push the cut out switch you can hear the relay click and the red ...

...spark to front cylinder,changed wires,plugs,coil,all check good...scratching my head...think perhaps broken wire...if not then ignition control.... Hi, Aecilak if you have a CKP sensor it needs ...

...spark plug with a new one and check for spark. For more information about your issue and free downloads that you will need please visit the websites below and for specific information or questions ...

Question about 2001 X1 lightning

1 Answer

Wont start has fire and can hear fuel pump.will run on starting fluid. So with fuel injection systems this can be a bit tricky, as it can be: 1. Fuel filter 2. Fuel hose. 3. Make sure fuel ...

...spark plug gap size for 2002 buell x1 lightning? what is the gap size Hi, Anonymous the correct spark plug for your Buell model is HD 10R12 or NGK DCPR9EIX and gapped at .040". With a dab of ...

where is the crank position sensor located on a 2002 buell x1 located? bike cranks but no spark . want to check crank position sensor but need to know the location. Check the fuses FIRST. Then look ...

...Spark plug gap too close or too wide. 4. Faulty ignition coil, module, and or sensor. 5. Battery nearly discharged. 6. Check battery terminals for damage or corrosion, check the battery cables at ...

...broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 4. Loose connection at ignition coil or plug between ignition ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...