TV and it was squished a bit. The actual damage to the cabinet is minimal. It almost appears as if the cabinet melted a bit. It is not cracked or punctured in any way. When the TV is on the picture is
Question about WD73727 73" HDTV
tv is in cabinet.. i pulled out and cleaned all vents.. not blocked by the way.. this would go on for a while, sometimes we could watch tv for a few hours sometimes not,,, now tv will only stay on for
Question about VS-60609 60" Rear Projection Television
...Cabinet? If so, the TV would be only 21 inches wide and it would be able to make the turn into our hallway to the new location. I have removed every screw from the back of the TV and the piece that ...
...cabinet base, or separate the tv into a couple smaller, more manageable parts? Unfortunatly no there isnt. The tv bottom contains all the circuits, color guns, speakers. From where the bottom of the ...
tv in closed cabinet I would like to hook up an IR Blaster to my Mitsubishi VS-5041 TV but cannot locate the DIP SWITCH. Please advise. Jae i don't know about the dip switch, but the ir receiver board
...TV APART FOR EASY MOVING. You cannot take the cabinet apart - because of the precise angles of the internal reflectors. However, you can take the projector out to lighten your load. A few screws on ...
Question about WD-62525 62" Rear Projection HDTV
tv and receiver in the same cabinet...or an area where the heat from one can affect the other. If so...you may have overheating. Also, be sure that airflow around the TV is good and that any air paths
Question about WS-65313 65" Rear Projection HDTV
...cabinet of TV still remain the same. Check below exploded views of WS-65313 for better explanation. Thanks. it comes apart. look at the side of the tv. remove the plastic plugs and you will see alan ...
Question about WS-65313 65" Rear Projection HDTV
...TV follow these directions: 1). Pull front speaker grill off 2). Unplug the 2 cables connectors in front 3). Remove 4 screws on both sides of cabinet (might have plastic covers) 4). Carefully lift ...
cabinet of the TV (toward the front), by hand - its somewhat/slightly flexible. If a tool is used, one risks damaging the cabinet finish, or the bezel itself.If I need to extract a screen, I'
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions