car stalls when i put it in drive or reverse, my 93 volvo 850 starts fine,when i put it in drive or reverse with my foot on the brake it stalls,if i put it drive without the brake it ok,if i step on ...
...car shakes and stalls. It 1992 mazda protege. When put into drive the car shakes and stalls. It starts right up and runs smooth in park. Also, it runs and does not stall or shake in reverse. I have a ...
...stalls when I put it in gear - even after it runs for 20 min. Sometimes it will stall while I'm driving. I had carborator replaced last year. Hope you can help. Some possible causes could be: Vacuum ...
...drive, stalls a little then jerks foward. When i apply brake, then accelerate, i stall, sometimes i will put in neutral at a stop light, then drive, so i dont stall. Recently, when i reverse, it is ...
Question about 1995 Econoline
...drive,didn't.Still stalls.Couldn't fix issue in reverse.Any ideas? Usually the problem is due to a dirty throttle body or a faulty idle air control valve. Stalling in reverse and not ...
Question about 1995 Econoline
...stalls when I stop while in drive or reverse. i just had an oil change and a tune up done. it only stalls while i am stoped and it is in the drive position or reverse. what could be the problem? run ...
stalls put reverse drive why is it stalling ? replaced fuel pump and filter. car will sit an idle but once in reverse or drive it will stall when you give it gas. also the clean the MAF sensor and ...
...drive Stalls when put into Drive or Reverse - Ford Truck Enthusiasts Forums www.ford-trucks.com > ... > 1987 - 1996 F150 & Larger F-Series Trucks May 22, 2012 - Stalls when put into Drive or ...
Question about 1997 Pathfinder
...car stalling when moving from Park into Reverse or Drive (I have automatic). ... I have been playing with the idle advance trying to get more ... I put in the remainder of the AT fluid I had on hand ...
Question about 2001 LeSabre
...drive it stalls and when i give it a little bit of gas it stalls but runs great in reverse The fastest way to check for the problem is to have a scanner hooked up to the obdii system and see which ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions