Questions & Answers for: Harley Davidson XL 1200 C Sportster Custom carb problems

will not idle problem occurred suddenly installed new plugs , new air claener fresh fuel hi buddy is it carb if so on carb is a screw turn this in the idle screw below if not carb get back to me

The sump overflows even after I changed the float needle The original Keihen carbs that come on Harley's are notorious for this problem. They've been a problem since they first came out with the carbs

FUEL ISSUES WITH CARB.. I have a 1990 Sportster 883 bored to 1200. The carbs were rebuilt two years ago and in that two years the bike was only rode about two hundred miles. I was riding the bike the ...

my bike starts fine but pops in the carb.any help? This sounds like the typical lean jetting problem. Has the bike always done this? If so, all you need to do is rejet the carb and make a couple of ...

need float specs fuel leeks out overflow on carb. hanging should it be right below the gasget at the toe or the seem? I would suspect that your problem is something other than the float setting. If ...

have a 92 883 sporty just rebuilt engine and carb i have dead on compression good spark and and carb seems to be working right but it will not fire up not even pop any sugestions would be helpfull ...

How hard is it to remove the carb on a 1995 Harley Sportster. The bike has not run in 4 years. I got it started but it won't idle under 2000rpms and runs rough. I think the carb needs a good clean

How hard is it to remove the carb on a 1995 Harley Sportster. The bike has not run in 4 years. I got it started but it won't idle under 2000rpms and runs rough. I think the carb needs a good clean

2000 sportster front cylinder backfires 2000 Sportster with newly added Mikuni carb won't run. When cranked, the front cylinder backfires out the carb. Is the exhaust valve not opening? What could be ...

...problems the carb leaks fuel when the bike is parked. I've changed the carb, and tore both carbs down. I found no problems in either of them. What can it be Either the needle and seat are not fully ...