HP PSC2355 all-in- one printer Carriage jam Try to move the carriage manually..it works most of the time....if still does not work...replace the printer. Moving the carriage manually worked. Use your ...
...- check printhead path error type 2 Something (not sure what) is obstructing the movement of the carriage assembly. Turn off the power and remove the cleaners. Push the carriage assembly out and ...
86-01 Error 86:01 still there. I replaced encoder strip twice, encoder sensor. Carriage PCB and Mech PCB. I'm out of options now. Maybe the scan ax motor, but during scan ax test the motor ...
Question about Designjet Z6100 InkJet Printer
Hello - the carriage has jammed. It was at a tab stop. Any advice please? It sounds as either the tab didn't knock off or the tab stop has been knocked out of place thus jamming the carriage. You can ...
typewriter carriage I have a Hermes 3000 typewriter. The carriage is not sitting at the left margin. As soon as it hit the left margin, the carriage moves fast to the right margin. Is the mainspring ...
print head carriage jam I see no obstruction except possibly a loose rail under the carriage toward the front. I have tried adjusting the position of this rail, pushed and pulled on the carriage, but ...
Question about Office Hero 6.1 Printer
the carriage return will not stop and keeps going back pinging the bell. The space bar appears to stop the carriage return but as soon as it is released the carriage returns.. the margins are not set ...
Question about Office Hero 6.1 Printer
When the typewriter is turned on, why does the carriage move hard to the left and continues to try to go farther left? The carriage has gotten forced out of its normal printing position. It has to be ...
kodak esp 2170 carriage jam problems turn on, printer error remove paper hit ok, done, then carriage jam 3527. carriage wont go to middle when open. when turn on printer makes short screeching noise. ...
Question about ESP Office 2170 All-in-One Printer
...adjustment bolt. Reinstall the slicer carriage and the knife and knife cover. Reconnect the slicer to the power source and test the drive belt to make sure it is functioning properly. I hope this ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions