...rough shifting.....where is this located on vehicle? Stand in fromnt of the car, the cam shaft position module is located on the front of the engine to the right hand side just below the fuel
Cam positioning sensor bank1 location chevy hhr 2.2 on the end of the motor opposite the drive belt.
...power going uphill. Replaced the spark plugs, now the car is very hard to start, once it does start it runs fine. Is this a sensor problem, or fuel pump? Check crank position sensor fuel relay and ...
cam position sensor location on 2009 chevy hhr These should help you out
cam shaft sensor crankshaft sensor plugs and boots...it still surges and im still smelling gas probably your spark plugs or spark plug wires...... change spark plug and try it if surge occur check air
cam pos sensor http://www.chevyhhr.net/forums/problems-service-repairs-42/reduced-engine-power-engine-shutdown-error-code-p0340-p0601-47411/page2/ Reduced engine power engine shutdown error code P0340
change a camshaft pos sensor on a 2006 hhr 2.4L code poo10 Hi Christine,here's a link on replacing your cam shaft position sensor. 3 DAY FLASH SALE Get 25 Gift Card For Every 100 Spent On Online Ship ...
...cam sensor position for bank 2. The sensor is telling the engine computer the cam is in a different position that it should be. You would need to check the signal from the sensor, and the actual cam ...
Question about 2007 HHR Special Edition
...cam sensor is same as front one No they are different, in basic terminology the front one is reading off the cam for the engine timing, while the rear one is reading for the fuel / air mixture, at ...
Question about 2006 HHR
...http://forums.edmunds.com/discussion/6909/chevrolet/hhr/chevy-hhr-brake-problems
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions