Questions & Answers for: change tps

Ad

Question about 1994 Regal Gran Sport

1 Answer

low voltage tps senser. 1994 buick regal gran sport codes low voltage tps. changed tps engine light still comes on. could the new tps be defective? Not likely getting a bad TPS.Your TPS runs off a ...

Ad

Question about 1993 Cutlass Ciera

1 Answer

...was hard to start before changing but only once in a while. I think it is just flooding itself out. Changed ignition module and mafs sensor. check for vacuum leak, could be power brake assist, high ...

Ad

...tps high input you will have to test tps sensor wiring also test sensor what was the reason you changed the computer plz comment reply if need more info plz incl test readings and engine ...

Question about 1996 Caravan

1 Answer

...reading to zero, then check for an open or a short on the signal wire and if none is found, suspect a bad PCM. If manipulating the TPS wiring harness causes any change in idle, then suspect bad

Question about 1996 Caravan

1 Answer

...reading to zero, then check for an open or a short on the signal wire and if none is found, suspect a bad PCM. If manipulating the TPS wiring harness causes any change in idle, then suspect bad

...SENSOR VOLTS  SHOULD INCREASE TO 4.3 - 4.8 VOLTS WIDE OPEN THROTTLE IF VOLTS DONT CHANGE WHILE PRESSING ACCELERATOR PEDAL EITHER TPS SENSOR WIRING IS OPEN OR SHORTED TO GROUND OR THE ECM

...body. The sensor is connected to the throttle blade shaft. As the position of the throttle blade changes, the resistance (output voltage) of the TPS changes.The PCM supplies approximately 5 volts ...

...constant ground clear the engine computer turn the key on push the gas pedal to the floor about 50 to 100 times if your 5v does not change and you have a good ground and the code returns the tps is ...

Question about 2001 Sienna

1 Answer

...TPS operation for comparison. Meaning that if the PCM sees a large percentage change in throttle position, it expects to see a cooresponding change in manifold pressure and vice versa. If it doesn't ...

...perfectly. Where do we go from here. Did you watch the TPS numbers on a scan tool in your car? TPS code means TPS bad or wiring or TPS adjustment. Change the TPS as they cost nothing and do wear

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...