ribbon properly Check support.epson.com for documentation & additional information. With this type of printer that is usually in heavy use in office environments, on-site service is recommended. Check
Question about 2280 Matrix Printer
...check ribbon " error is comming on my tally 2280+ serialprinter tally genicom 2280+serial printer The ribbon I had installed (code 061627) which says it is the correct one is in fact not. the drive ...
...that is OK then check the ribbon driver it should move freely and swing to the ribbon take up spool. Some WD40 will free it up. Also be sire the ribbon is winding in the direction of the arrows. ...
check ribbon' hardware alarm... carriage moves ok, 2 new ribbons ...that came from other machines,,,, ribbon drive seems fine, could it be encoder strip??? please help! The check ribbon message on the
ribbon is installed??? Check this!! Take out the ribbon and run a print without the ribbon.While printer is printing check if the small pin of the ribbonholder is spinning. When yes there is a problem
...Check that the ribbon plate assembly is not in the correction position. Try CODE RESET (Q key) You have to use the Code "RESET" (Q) in order for the ribbons to get properly reset after you have ...
Question about 110PAX4 Thermal Label Printer Print Engine - P/N 113el01-00000
...Check that the metal ribbon blade spindles are in place. these hold the ribbon core in place.Also make sure the ribbon is not loaded over the ribbon reflective plate.( under the head mech where the ...
...Check Ribbon Error" after printing 2 or 3 pages. Sometime it prints 7-8 pages and sometime it prints 2-3lines only and shows check ribbon error. Carriage shaft is dry. tried with another encoder ...
showing Ribbon Fault hiclean the ribbon then if still same error chang the ribbon first replace ribbon then clean ribbon sensor at left side if not check cable to motor of ribbon works properly
...Check the ribbon for any damage or wrinkles. If there is any damage, replace the ribbon with a new one. Ensure that the ribbon is installed correctly in the cassette and that the cassette is inserted ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions