Questions & Answers for: checking oil yamaha dt 125

...125 4 stroke 2005 model does anyone know how much oil it takes,once drained Pick up the phone and call the dealer. Barring that, drain the oil then put one quart in the gear box. Now check the oil ...

oil checking yahaha dt 125 r 1999 how do i check the engine oil? Here is the manual which may be of help. Not certain if you have a small window low down in the engine that shows oil level or the oil ...

"my dt125 is trying to fire but struggling ''my dt125 2007 model is trying to fire but struggling when it does it wont idle cuts out'' carb is dirty or engine is low on compression should be ...

Yamaha dt50x 2007 EU-type. When I start up it runs directly to about 6000rpm. Then it goes down to 3000rpm. There's no strengt in the motor when I try to drive away. This problem came direct. It has ...

Yamaha DT 125 oil pump settings Yamaha DT 125 2007 model. I would like to know how do i check if the oil pump has the right setting. If you ride slowly for some time and then when you open up there is

...YAMAHA DT 200R does not work since the oil pump does not pump the oil to the piston.I do not know why? Could anyone please help me on solving this problem? Clean out the oil tank Clean out the oil ...

yamaha dt 125 r 2001, was overheating, i took me rad off and can smell fuel in the rad, ive put a new headgasket on and thermostat housing gasket, cud any1 tell me what else to check,that would of ...

...Dt 125 MK3 and that smokes much less. What is causing mine to smoke so much? I have checked all settings with oil pump. I have replaced head gasket. I have monitored gearbox oil level. Any ideas much ...

...yamaha dt 200 1996 that will oil up terribly when left to sit for over a day. Starting isn't too much of a problem except for when the bike has been sitting. Any thoughts on how to fix? Not familiar ...

...oil leak on my Yamaha DT125R 20011. it's leaking from around the gearbox/ Gear lever region but i just can't see where exactly. ive cleaned it all too. ??? Hi, Anonymous it may be your shift shaft ...