Questions & Answers for: Cadillac Brougham chev 5 engine problems

...5.& (chev) vin number-7 5.0 (307 olds) vin number-Y if you get under the car there will be a number stamped on the engine over the oil pan area. you can match that to the Vin number on the car bottom ...

...5.0 litre with 150,000 miles I am using Mobile 1 synthetic 10w30 oil,The oil cap says to use 5w30.The previous owners used 10w30 as the car was in Florida for 6 months a year and is stored in the ...

problems,you can use either without any negitive effects. If anything i would bump it up to a 10w40 with that kind of milage engine is prety loose, just stick with the same brand of oil just go heaver

...problems for a 93 Cadillac Deville The battery is new and fully charged and the car won't start. New information on how to replace the starter. my 93 brougham starts up fine. You can go may be one or ...

...5. Install new thermostat, pointy side towards radiator. 6. Use Permatex #2 (non-hardening sealant) on both sides of the new gasket and bolt down the housing. 7. Replenish cooling system. 8. Start ...

my service engine light keep coming on once i reach high speeds over 60 mph Hi, This is a problem that affects many cars and trucks. Usually it is a matter of a tune up. When the sensor detects that ...

...5 L. (307 olds?) with electronic advancement of distributer. It was running fine until I replaced the throdle position sensor. Now it has problems while cold (stalls) and always truble with ...

...and housing aren't even close. Just about any olds motor (you can find them at any salvage/engine rebuilder pretty reasonable) will bolt in. It would take alot of work to work the chev into

When oil capacity is low the engine oil light appears saying "Stop engine oil pressure." FastTrack Auto Service told me that I had an oil leak wear the engine and transmission meet. If so ...

...that one panel with no reference at all...thank you for your answers!! My daughter did that to my Chev truck as I did not want her to play with the lighter. It is probably on the firewall under the ...