Questions & Answers for: choke cable adjustment

...choke cable and, basically, make sure it does not get kinked or pulled tight when the handlebars are turned from side to side. Then, remove any excess free play in the cable by turning the adjustment ...

choke cable, there were clues. Thanks! The problems with a plunger style choke happen when the rubber on the bottom becomes deformed and does not seal or the spring does not push the plunger down hard

...when you take choke off Hi there, The choke cable needs adjusting. There is a strap holding the sleeve on the carb. loosen it and adjust the choke position, then tighten it up again. Thats it ...

...choke cable may be detached or far out of adjustment. With a helper see if you can watch the choke cable move the choke lever on the carbs when you move the choke lever to full choke. Cables do break ...

restarting have to do the same thing Hi Ted, most likely the choke is not coming on fully. To fix this adjust the choke cable or if the choke is on the throttle adjust the throttle cable. Regards Phil

...adjustment or rebuilt most likely The choke cable has an adjustment on it... it may not be pulling the plunger up enough to work properly.. a good cleaning/setting by a professional should fix

...Good luck and have a nice day. Grizzly 600 Choke Cable adjustment How to Set Up and Adjust Throttle and Choke Cables on Small Engines PDF Moto Manual OEM parts for Yamaha Yamaha DT230 Owner ...

...choke cable Most choke cables are non-adjustable. If you think about it this makes sense. The choke is only for assisting the bike before it's brought up to operating temperature. So there is no need ...

...cable fully forward, re-tighten the clamp. This should allow the choke to close fully. Remove the air filter so you can see the butterfly and verify it is fully closed. If it is not opening fully, ...

...choke cable? Hi Jim: Make, Model Year Carb? Probably yes since you mention choke - Idle is adjusted by screwing the throttle stop screw in or out. - Choke cable is adjusted by slacking off the outer ...