Question about Pro Chain Saw 46cc 20"
...choke in the run position and give it gas, it dies. Will run great when the choke is in the mid position. The prob is at the base of the carb. Its sucking air. Be certain to install a new gasket, ...
...set fast idle (done when choke closed on some saws) ? Do not pull with choke closed or at 1/2 choke position. Push (open) choke, pull starter until it starts. (usually first pull). Hope this helps. ...
Question about 25cc 2-Cycle Gas Powered String Trimmer #P2500
...choke position. Please advise. just bought a new Poulan 25cc 2cycle gas power weed eater . I can start it with the choke on but as soon as put on run it dies. A few things to check, then clean or ...
Question about P4018 18Inch 40cc 2Cycle Gas Powered Easy Start Chain Saw With Case
choke position and if I haven't gotten a start in maybe 8 pulls I return to the choke position for one or two pulls. I am sure this varies with different chainsaws, but you shouldn't have to pull very
...choke either in or out, the other type is connected to the half throttle position, once pulled out it stays out, however if you lift the throttle trigger it will go back in on its own, queation, are ...
Question about Pro 16-Inch 38 cc Anti-Vibration Chainsaw #PP3516AVX
...choke system is connected to the half throttle position, if you lift the throttle trigger the choke pull will automatically return, whilst trying to start do not lift the throttle trigger, the ...
Question about Weed Eater No Pp446t 952802025 31cc Gas PrunerTrimmer
...choke. then run inrun position for a minute and have to go back to choke to keep it running ,then it runs fine for a couple of minutes and have to go back to choke and start all over again. Try ...
Question about FL1500LE 25cc 150 MPH Blower
...choke is moved to the off position, the blower slowly goes dead. Like it is straving for fuel. How long are you leaving the choke on? Try leaving it on a little longer and then move it to the half ...
Question about FL1500LE 25cc 150 MPH Blower
...by choke when it is in off position and you set choke to full which in turn sets switch to on/run other wise pushing down on the switch will set it to off regardless of what the choke lever is set
Question about Pro PP5020AV 50 cc Gas Powered 20-in Chain Saw with Case
choke soses choke engages and saw dies out when using saw Choke leaver worn at carby or the lock off position worn.
Usually answered in minutes!
583 Questions
457 Questions
255 Questions