clutch lever mount on the handlebars) 2.Now open the derby cover. (The round cover on the back of your primary cover. Not to insult your intelligence. This -> https://www.denniskirk.com/jsp/product
Question about 2003 XL 1200 C Sportster Custom
clutch inspection cover screws and remove the cover. Note: When removing the clutch inspection cover, work carefully to avoid removing or damaging the quad ring in the primary cover. (the quad ring is
...cover. Inside you'll see the clutch assembly with the adjuster in the center. Loosen the large nut and turn the adjuster bolt inwards until you feel resistance. Do not force the screw, turn it until ...
cover that protects the clutch cable adjuster. Move this cover up or down, loosen the locknut, and adjust the adjuster inwards to gain a good deal of slack in the cable. Now, remove the primary cover.
cover, and the clutch snapping back to normal, tell me anything I should do/look for or, was it just a fluke and there's something inside that is wrong with the new clutch...I'm not a mechanic
slack from cable but leave about 1/8" (3 mm) slack on lever. If clutch still slips, then more than likely clutch plates gone. Smell will be quite obvious when derby cover is removed if clutch is burnt
clutch cable adjustment is about 1/2 way down cable. Remove derby cover on primary cover. Looks similar to this: http://www.hdforums.com/forum/attachments/touring-models/118583d1274757072-derby-covers
...clutch inspection cover and back off clutch adjusting screw lock nut. Screw in adjusting screw untill resistance is felt then back off 1/4 turn. Tighten jam nut and replace inspection cover. With ...
Question about 2003 XL 1200 C Sportster Custom
...clutch inspection cover quad ring onto the primary chain case cover. 11. Install the clutch inspection cover and tighten the screws to 84-108 in.-lb. (9.5-12 N•m). I'm not sure how you can do that ...
...the cable adjuster. 10. Install the clutch inspection cover quad ring onto the primary chain case cover. 11. Install the clutch inspection cover and tighten the screws to 84-108 in.-lb. (9.5-12
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions