Questions & Answers for: Honda clutch cover

Question about 2007 CBR 1000 RR Fireblade

1 Answer

...clutch on honda cbr1000rr 07 Hello not sure which side cover the clutches are behind the brake side or the gear leaver side. Also there are 2 different types of clutch fibers on the cbr clutch ...

Ad

Question about 2005 CR 125 R

1 Answer

...power from the engine to the transmission. drain the oil and remove the side cover to access the clutch basket. you'll need a new side cover gasket as well as a new clutch pack (friction &

Ad

Question about 1997 VTR 1000 F Firestorm

1 Answer

...still not fixed plz help. Mel! the cover that you took off to do the front sproket is where the clutch push rod gets pushed by the slave cylinder take cover off thats the only thing that could go ...

...clutch removal and right side cover 2000 ace deluxe questions on clutch removal and right side cover removal 750 ace deluxe. 2000 Hardest part of doing a clutch is having airtools to nock off the big ...

Question about 1988 VT 1100 C Shadow

1 Answer

...problem that the clutch plates glue them selves together. You will need to remove the clutch outer case cover and disassemble the clutch and one by separate each plate re oil them and reassemble

Question about 1987 GL 1200 Aspencade Gold Wing

1 Answer

...cover and tighten the screws loosely. 6) Apply the Clutch Lever, slowly, several times and hold the lever in the applied position. Open the Bleed Valve and allow the Clutch Lever to compress ...

Question about 1987 GL 1200 Aspencade Gold Wing

1 Answer

...clutch cover. After draining the oil, remove the cover and this will expose the clutch pressure plate that will be retained with a number of washered bolts and springs. Remove the pressure plate, and ...

Question about 2005 CRF 450 R

1 Answer

clutch cover seal I am trying to replace the clutch cover seal. It doesnt fit. It is the same length as the old one. It seems to be to big. Is there a trick to install the seal on the clutch cover? ...

Question about 1988 VT 1100 C Shadow

2 Answers

...cover was put back on the clutch would barely move. Looked like the little "pin" in the middle of the assembly (not sure of the technical term) where the oil comes out was hitting the inside of the ...

...clutch is replaced the cover and forgot something about the clutch cable you have to adjust the clutch cable to ensure there is no slack in the inner cable so that the tension is restored?? Just like ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...