Questions & Answers for: kawasaki clutch cover

...clutch cover gasket Unhook clutch cable at clutch cover Remove clutch cover Remove 5 clutch spring bolts Remove springs Remove pressure plate Remove plates and disc noticing order Replace with new ...

...cover and push the clutch shaft inward about 1/4". Now re-insert the clutch arm and put the left cover back on. Next tighten the clutch springs, 22ft lbs, then put the right cover back on. All Fixed! ...

...clutch cover plate off. Need to replace broken oil level window but can't remove the clutch cover plate from right side of engine. All bolts removed, cover will not lift; feels like cover plate is ...

clutch outside cover, pulled the clutches apart one by one and oiled them up replaced everything and still no clutch.....any ideas...bad clutches or bad tranny? any help is appreciated oh and one more

...clutch slave cylinder behind this cover. I found the best way to bleed the clutch is to fill the master and open the slave and let it drip for a while (gravity bleed) Do not let the cylinder at top ...

Torque specs for a zx10r clutch basket springs and cover clutch springs - 7.2 ft lb ; clutch cover bolts 8.7 ft lb

...cover and tighten the screws loosely. 6) Apply the Clutch Lever, slowly, several times and hold the lever in the applied position. Open the Bleed Valve and allow the Clutch Lever to compress ...

...clutch cover is removed in a two step process. Remove the clutch cable by loosening the adjustment at top and bottom first. Then remove the cable end from the clutch lever. This should give enough ...

...clutch bleeder is behind the left engine cover, you will have to remove the left exhaust from the head and also the left front foot peg in order to get it off should be about 5 bolts holding engine ...

...clutch cover with about 10 bolts securing it , might have to remove the foot peg and brake lever also ! Once cover is off then you will see the clutch assy , remove the end cover with about 6 bolts ...