Questions & Answers for: Nissan clutch cover

...for the clutch. On the slave cylinder itself and under the hood on the passenger side. Its right behind the windshield washer fluid fill spot. Sometimes the bleeder is covered with a black

...clutch cover is to be used again, it should be replaced in its original position. Make a centerpunch mark on the flywheel and on the clutch. CAUTION Use a HEPA vacuum to vacuum any asbestos dust from ...

My car sat for about 5 months in the yard. Clutch and transmission are new rebuilt. Went to move the car clutch went to the floor and stayed there. What can I do? Sounds like you either need to bleed ...

what are the torque specs for the flywheel and clutch for a 1990 nissan 300zx non turbo? Flywheel 61-69 ft/lbs Clutch cover to Flywheel 25-33 ft/lbs

hydrolic clutch fluid comming out of bell housing you will need to replace the clutch release cylinder there's a hydraulic cylinder that pushes the clutch out of engagement.it sounds as if the seals ...

...clutch master cylinder. Pull the cap off of it and see if it has any fluid in it? If it is at least one third full than you shouldn't be experiencing that problem, in which case you would be wise in ...

...clutch isn't working correctly if you have to go through all that to get it into gear. You can check the shifter rails on top of the transmission, but that takes removal and dis assembly of the top ...

...cover resulting in clutch engagement problems If you have a cable clutch then that is made worse by bad engine mounts. Remember what you did and what you should have done and you will have the answer ...

cover it under the manufacturers warranty? Clutch was fine one day, smelt a burning and took it in to the service department to find out that the clutch needs to be replaced. Nissan says its fair wear

...plate 'fingers' worn or seized release bearing ? Please advise. Jerry Replace clutch,bearing and cover plate check fly wheel while assembly is off for wear and spigot bearing in center of fly ...