Questions & Answers for: Yamaha clutch cover

Question about 2004 V Star Classic

1 Answer

...clutch cover, it is on the clutch hub. The adjustment for this would be done by removing the clutch cover to access the clutch hub. On the outside of the hub there is an 12mm nut locking down a 6mm ...

Ad

...clutch cover gasket. Take clutch cover off, remove 5 bolts and pressure plate, pull each plate out one at a time keeping them in order, replace with new plates, new plates go in same order. Soak the ...

Ad

Question about 1996 Royal Star XVZ 1300 A

2 Answers

...clutch cover will have to be removed and the clutch examined. If you intend to perform the repair, I would suggest that you buy a service manual from Yamaha , Clymer or Haynes for specific ...

clutch cover is facing up. pull the clutch cover off. go to home depot and but a package of 6mm washers. take the 5 or 6 (cant remember how many there are) screws out that have the springs under them,

Question about 2004 Royal Star Venture

1 Answer

...cover), and pump the clutch lever, periodically refilling the reservoir on the handlebars, until the fluid coming out the drain is clear and free of bubbles. Remove the flexible tubing, tighten the ...

Question about 1999 YZF 600 R thunder cat

1 Answer

know if it will do any thing to my clutch when I remove the cover over the front sprocket were the clutch cable goes into? Removing the cover should not affect the clutch at all. Please rate my answer

Question about 2008 Royal Star Venture

1 Answer

...from the Clutch Master Cylinder hydraulic hose all the way down to the Clutch Slave unit,,,The bleeder niple is right on the back of it,,,It may be covered with a black rubber cover.,,hope this

...Cover - Clutch Adjusting Cover Loosen the locknut Turn the adjusting screw in until it is lightly seated - Be careful, the screw will keep turning with enough pressure. Just turn it in lightly until ...

Question about 2004 V Star Classic

1 Answer

...clutch cover out and found the throw out bearing and a small round bearing inside cover I went online to figure how to install clutch plates and reassembled the clutch according to specs,installed ...

clutch by removing the right-hand side cover and also removing the starter you can Utube the procedure im pretty sure but its pretty basic to do once your inside the cover and also you may wanna drain

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...