Questions & Answers for: clutch cover Motorcycles

Question about 1995 Maxima

1 Answer

...clutch cover is to be used again, it should be replaced in its original position. Make a centerpunch mark on the flywheel and on the clutch. CAUTION Use a HEPA vacuum to vacuum any asbestos dust from ...

Ad

clutch cover removed clutch cover to replace chain and I cannot get to release so I can reinstall clutch cover Hi there Sometimes that's not an easy job . I work for a Husqvarna dealer and I have that

Ad

...clutch cover. ideas? Clutch fluid leaking from clutch cover. ideas? The clutch cover leak is a common issue on the original design, and there is a fix available. Go to your Buell dealer with part ...

Question about 2003 XL 1200 C Sportster Custom

1 Answer

clutch inspection cover screws and remove the cover. Note: When removing the clutch inspection cover, work carefully to avoid removing or damaging the quad ring in the primary cover. (the quad ring is

Question about 2003 XL 1200 C Sportster Custom

1 Answer

...clutch cover is removed in a two step process. Remove the clutch cable by loosening the adjustment at top and bottom first. Then remove the cable end from the clutch lever. This should give enough ...

Question about 2002 GSX 1300 R Hayabusa

1 Answer

...clutch cover now i vpull the clutch it grinds G'day. that dosn't sound good. If ALL you did was change the cover & didn't touch anything else(like the clutch) ,it will likely be the ...

clutch cover off. That rod connects to the clutch push button. sounds like it fell out. Undo all the little clutch cover bolts. Carefully pull the cover off leaving all the clutch plates in a stack as

Question about 2000 FXDWG Dyna Wide Glide

1 Answer

...the cable adjuster. 10. Install the clutch inspection cover quad ring onto the primary chain case cover. 11. Install the clutch inspection cover and tighten the screws to 84-108 in.-lb. (9.5-12

...cover of the clutch lever to reveal the lock nut and adjusting screw. Loosen the lock nut with a wrench. Tighten the adjuster screw until it won't turn any more. Step 2 Remove the left frame cover of ...

...clutch cover not fitting on the machine. Does the spring inside of the cover fit inside the clutch wheel or around the outside? Could not find a diagram or instructions in the owners manual. Bought a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...