Question about 2008 FLHRC Road King Classic
clutch inspection cover from primary chaincase cover. 3. Remove and discard seal. 4. See Figure 1-20. Add free play to cable. a. Slide rubber boot (1) off cable adjuster. b. Holding cable adjuster (2)
...cover off, you'll see the clutch pressure plate. In the middle of the plate, you'll see a screw with a lock nut on it. Make sure the bike is in neutral. Break the locknut loose. The engine may try to ...
...clutch cable I assume you mean it leaks where the cable goes into the transmission cover on the right hand side? The cable at that end has an o-ring to seal it, and yours might be bad, and needs ...
...cover you removed to replace the clutch cable. There is a large plug that takes a 3/8" Allen or Hex key to remove. Remove the plug and there is a dipstick on it. You should have seen this when you ...
cover. Take the engine sprocket nut off, take the clutch adjuster out of the center of the clutch assembly and remove the mainshaft nut. This nut has LEFT HANDED THREADS. Remove the nut that holds the
clutch lever in to prevent a stall. What this does is puts a load on the chain, tightening the top run, and giving maximum looseness to the lower run, where the adjuster works off of. This (in theory)
Usually answered in minutes!
107 Questions
23 Questions
9 Questions