Questions & Answers for: Harley Davidson FXD Dyna Super Glide clutch cover

Question about 2002 FXD Dyna Super Glide

1 Answer

clutch lever mount on the handlebars) 2.Now open the derby cover. (The round cover on the back of your primary cover. Not to insult your intelligence. This -> https://www.denniskirk.com/jsp/product

Ad

Question about 2002 FXD Dyna Super Glide

1 Answer

...cover and then the nut its a right is tight...clutch side the nut is first its a left is tight then the rod cover with the words out ( out) and the snap ring. compensating sprocket is 150 ft lbs and ...

Ad

Question about 2002 FXD Dyna Super Glide

1 Answer

cover at the clutch. When you look in you'll see the clutch assembly. It's made of aluminum but there's a black looking disc inside the outer clutch housing. This is the diaphragm sping. The oil level

Question about 2000 FXD Dyna Super Glide

1 Answer

...cover from your primary. In the center of the clutch assembly you'll see a screw that takes a hex key or allen wrench. Loosen the lock nut. Turn the screw inwards until it meets a resistance. Do this ...

Question about 2000 FXD Dyna Super Glide

1 Answer

...cover from the primary. Inside, you'll see the clutch assembly with the adjuster screw in the center of it. Loosen the locknut and turn the adjuster screw inwards until you feel a resistance. DO ...

Question about 2000 FXD Dyna Super Glide

1 Answer

...clutch and primary bolts Install primary cover and gasket using the sixteen screws with captive washers tightening in sequence from center to front alternately top then bottom the middle to rear ...

Question about 2008 FXD Dyna Super Glide

1 Answer

...cover. Inside, you'll see the clutch assembly with the clutch adjuster screw and lock nut in the center. Loosen the lock nut and turn the adjuster screw inwards (clockwise) until you feel a ...

Question about 2001 FXD Dyna Super Glide

1 Answer

...2001 dyna super glide What are the torque screw specs and sequence for replacing the clutch inspection cover Tighten inspection cover screws (13, 14) to 84-108 inlbs (9.5-12.2 Nm). in a cross ...

Question about 2000 FXD Dyna Super Glide

0 Answer

how to remove clutch hub 93 fxlr Hi Anonymous, for more information on your question please visit the websites below and good luck: Stator Repair 1 of 9 Removing Inspection Cover on Outer Primary ...

...of the clutch problem. What was done with the bike just before the present problem??? Has the cable been properly adjusted?? Has anyone taken the clutch release cover or the cable out

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...