...Tighten the jam nut. reinstall the derby cover and adjust the clutch cable back out untill there is one sixteenth inch slack in it. Operate the clutch lever several times to reset the ramps then ...
...cover causing a bind in the jackshaft and preventing it from coming out and engaging the ring gear properly. Good Luck Steve Well, I would suggest to get faster to a Dealer in order to check out the ...
...cover. There is only one large nut on the front pulley but you've got to pull the entire clutch assembly and inner primary to get to it. Go to this site to get an idea of how your bike is put ...
...clutch remove the derby cover and then is if the 11/16 lock nut in the center of the clutch basket came loose.if it did reajust the clutch at the same it you can see if the cable and the clutch ramp ...
...cover (over clutch pack). Pour primary fluid through derby cover hole until level comes up to just the bottom of the clutch plates. ------------------------OR------------------- 2: With bike on kick ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions