Question about 2000 XL 1200 C Sportster Custom
...clutch. I took off the derby cover and figured out that the adjustment screw was hitt I replaced the clutch in my xlh1200 1995 with a kevlar clutch kit. when I put it back together I couldnt squeeze ...
Question about 2003 XL 1200 C Sportster Custom
clutch inspection cover screws and remove the cover. Note: When removing the clutch inspection cover, work carefully to avoid removing or damaging the quad ring in the primary cover. (the quad ring is
...cover. To adjust the clutch, find the cable adjuster in the clutch cable. It's usually covered by a rubber bellows type cover. Slide it up or down, loosen the lock nut, and turnt he adjuster inwards ...
...clutch release mechanism cover from the outer primary. Remove the spring and locknut. Turn the clutch adjuster screw as far clockwise as you can turn it. Then remove all the bolts around the outside ...
...cover. Go back to the cable adjuster and turn it outwards until you have about 1/8" freeplay. work the clutch a couple of times and recheck the freeplay. If the clutch still slips, time for new ...
...cover..the clutch cable enters the transmission just a little bit towards the inside of the motor..fluid is leaking from that cover..how do i replace the covers gasket..i guess its the clutch ...
...cover back where the clutch is. A lock nut and small spring will come out. There is a threaded screw in the hole that is a clutch adjustment. Turn this screw clockwise to get your primary cover off. ...
...clutch inspection cover, being carfull not to dislodge large quad seal on primary cover. Remove spring and hex lock plate from adjusting screw. Turn adjusting screw counter clockwise until resistance ...
Question about 2004 XL 1200 C Sportster Custom
clutch inspection cover (derby cover) which is secured with four T-27 Torx screws. You would add fluid here and only up to the bottom of the clutch diaphragm spring. There is another small cover plate
Question about 2003 XL 1200 C Sportster Custom
...clutch inspection cover quad ring onto the primary chain case cover. 11. Install the clutch inspection cover and tighten the screws to 84-108 in.-lb. (9.5-12 N•m). I'm not sure how you can do that ...
Usually answered in minutes!
586 Questions
351 Questions
242 Questions
159 Questions
145 Questions