Questions & Answers for: Harley Davidson XLH Sportster 883 Hugger clutch cover

...cover, disconnect the clutch cable from the ball and ramp then remove ball and ramp. You should now see a post with a slot in it, take a screw driver and snug it down then back it off about a quarter ...

...clutch cover side I'm confuse a bit but I'll try to help. You say you're having problems with the belt drive and getting the clutch cover side off. The heading on this post says you have a '93 XLH ...

...clutch inspection cover, the small spring, and the locknut on the clutch release mechansim. Remove the left hand foot peg. Remove all the bolts holding the outer primary cover on. As you remove the ...

cover and then turn the clutch ajuster inwards as you pull the cover off. The cover will come off. Then to install the cover, hold it up to the clutch adjuster and turnt the screw counterclock wise as

...cover off? You have to take the small plate at the clutch off. Remove the plate and take the spring and locknut out. Inside you'll see a screwdriver slot. Turn this screw clockwise while gently ...

...clutch cable in place. Remove derby cover, the large round cover where the cable enters buy removing the four hex screws. Remove spring with attached hex lock plate. Use a flat head screw driver to ...

...clutch maybe out of adjustment. When you replaced the cable did you readjust it? Also there is a a spring that attaches to a hex nut behind the derby cover that holds the adjuster in place. This ...

...cover and look for missing ramp balls and or c-clips and snap rings. grab the clutch pack and see if has abnormal movement either in and out or up and down. Clutch hub nut could have loosened but ...

...883 Sportster. I installed new friction plates on my Sportster and it will not go into gear. The clutch doesn't grab at all? My bike has the Chevy inspection covers on it so I never took the