signal code. I have replaced both cam and crank position sensors I can see on the snap on vantage occiloscope that the PCM is receiving both crank and cam signal and is sending the signal too the FICM
...code 12 The codes showed are... Fault Code 12 Description: Memory standby power recently lost Power loss light: Off Limp-in mode: None Possible Causes:* Battery or power line recently disconnected - ...
...code's ,see if the climate control module will communicate with the tool . HVAC Control Module The HVAC control module is a class 2 device that interfaces between the operator and the HVAC system to ...
...signal at this input indicated to the PCM that the ASD has been activated. This input is used only to sense that the ASD relay is energized. When energized, the ASD relay supplies battery voltage to ...
...distributer cap. These often fatigue where they exit from the sensor. Upon replacing the sensor, make sure the cables are clipped or tied to the distributor cap shroud (or elsewhere) so they do not ...
...ignition key is on. There is also a ground wire, and then there is a third wire, the signal wire to the pcm. If no data from sensor, first check the power and ground to the sensor. A voltmeter, one ...
Question about 1995 Intrepid
...ignition 1 input of the IPC. When the engine is ON, the gauge should be between 10 and 16 volts. The only one that has a hard wired sensor is the oil pressure gauge. Engine Oil Pressure Gauge The IPC ...
...code and symptoms. I looked inside the power distribution box and found 1 blown fuse (for the ECM) and under the driver's side dash I found 3 blown fuses (power outlet, trailer brakes and gauge ...
Question about 1995 C/K 2500
...signal; main to run theTBI is old and its pressure regulator can be bad./ one trick I use (means tactics) Is that I kill the fuel pump fuse or its relay pulled. this hides the bad TBI fully and now ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions