...exact same problem with a friend's 89 camry. After reading many forums I tried replacing the coil (resistance was below spec) and temp sensor to no avail. I spent days under the hood of this ...
coil ? what are the specs? Car ran rough when "cold" then ran fine after 3-5 minutes. All of a sudden, dash lights went on- car coasted to a stop. Car will not start, turns over, fuel pump is working,
Question about 1993 Camry V6
...8/6/09: (Japanese celica motor in it has: 140,000) Odometer reads: 206,000 Last ignition switch and coils replacement: Sep 06 @ 145,000 mls Last New Timing belt, steering belt, alternator belt chg: ...
...specs. It passes smog and is otherwise in good shape. I am wondering if maybe fuel injectors are tired but am hesitant to just start changing parts. I had a Toyota corolla that had a similar problem ...
coil primary and secondary with ohm meter and see if it meets resistance specs. https://www.youtube.com/watch?v=_a36Q9h1kAQ watch the video. i couldn't find anything anywhere that had
Coil Pack is Functional, you May Need to Check ALL of these Wires if FUEL Pressure is GOOD and This all Applies on the 4 Cylinder 2.2L. and the 6 Cylinder 3.0L DO ANY FUEL TESTING IN a WELL VENTELATED
coil and found the primary resistance was 1.7 ohms (Specs 0.4 to 0.5 ohms). I replaced the distribuotr and still no fire. I found the replacement dist had no air gap (Bent mounting plate) and returned
...coil but not off plug wire. pulled cap off and cranked engine and found rotor does not spin. is there a belt or chain for timing that could have broke? just got car cheep. previous owner said they ...
the car will not start I did a complete over haul of the engine compression is 140-psi in all cylinders new fuel pump and injectors the crank and cam positionsensors are within spec the ignition coils
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions
