...I have an 89 Katana and don't know where the two vacuum lines on the top of the carbs go I have the connection shematics. I'll try to explain, if needed send me your mail address, I'll send you a ...
...often difficult to trace. There are many possibilities to look for. The problem could be a loose connection, a broken hose, a cracked component, or a defective seal. It could also be a hole in the ...
from the heater connection and connect that hose to the other hose connection at the engine. Take the free end just removed and connect it where the first hose connected at the heater. Hope this helps
...overflow hose connect to? OVER FLOW HOSES YOU HAVE THREE HOSES THE 3/4 INCH HOSE CONNECTS TO TO RADIATOR TWO SMALL SURGE HOSES ONE CONNECT TO TOP OF RADIATOR THE SURGE HOSE GOES TO THERMOSTAT
...Connect the lower radiator hose to the water inlet connection. Fill the engine with coolant, start the engine and check for leaks. Stop the engine and top off the coolant recovery reservoir as ...
...Connect the upper radiator hose to the water hose connection. Fill the engine with coolant, start the engine and check for leaks. Stop the engine and top off the coolant recovery reservoir as ...
...Connect a garden hose to the threaded drain hose connector. 3. Push hose connector tightly to the drain-hole on Rear Grille with the arrow on the tab pointing UP. The hose attachment will accept a ...
...or attachments. Fortunately, it doesn't require a special hose, as a standard Garden Hose Connection is on the left side of the water collection bucket. You may have to carefully drill a
water leaks from underneath my washing machine. how do I fix it? the hose is connected properly, too Water leakage 1. Inlet hose loosely connected to valve---tighten hose connection 2. Drain hoses not
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions