Questions & Answers for: Chevrolet convert 1

1984 s10 sound If I order a catalytic converter do I order the same exact size pipe? like if the pipe that goes into the catalytic converter is 2 1/4 inch do i order a catalytic converter that has a 2

...referred to as Bank 1. Sensor 1 is always the upstream sensor (The one located BEFORE the catalytic converter) Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic ...

...is on the drivers side youll have 4 O2 sensors sensor 1 bank 1 is on the engine side of the cat converter sensor 2 bank 1 is after the cat converter (drivers side ) bank 2 is on the passenger

...but i do not know where it is to replace it. Please help! The O2 sensors located beside the cat converter.The one is pre-cat converter and other is pro-cat converter.The 1 before the catalytic ...

...1997, what exact sensors do i need for bank 1 and bank 2 sensor1 Well upstream from the Catalatic Converter means towards the engine and that would be the location for Sensor #1 on both sides of

...to where blank 1 sensor 3 is on a 1997 chevy astro van is located Bank 1 Sensor 3 is the post converter sensor. Hope this helps (remember to rate this answer). Hello: Bank 1 is on the side that ...

2 codes 1) P0420 catalytic converter system below threshold (bank 1) 2) P0420(Pd) catalytic converter below threshold (bank 1) possible causes for code po420 airleaks at the exhaust manifold or in the

...02 sensors, they are located as follows: Bank 1 Sensor 1 - Driver's side, before catalytic converter Bank 1 Sensor 2 - Driver's side, after catalytic converter Bank 2 Sensor 1 -

...1 sensor, bank 1 sensor 2 or bank 2 sensor 1, bank 2 sensor 2? O2 sensors are always after the cat converter and HO2S sensors are always before the cat converter. p0135 refers to heated oxygen

...convert exhaust emissions effectively. If the catalyst is functioning correctly, the Bank 1 HO2S #2 signal will be far less active than that produced by Bank 1 HO2S #1. Read more: ...