Can't get screwdriver bit out hold the bit into the bench vise & pull the drill wiggle at the same time.
Question about 18V LXT Lithium - Ion Cordless Impact Driver Kit Model BTD140
bit stuck in quick release chuck - makita btd142 What has happened is the hex part of the bit has twisted slightly making it hard to remove. What I would do if you are comfortable with partial ...
Question about Pivot Plus Cordless Drill/Screwdriver
black & decker pivot plus bits are stuck I can't get the bit out. I don't have the manual anymore, is there some sort of trick to removing the bit? I had this problem too, an unfortunately, there's no
Question about DC925B Heavy Duty Xrp 18V Cordless Hammerdrill/Drill/Driver Bare Tool
drill doesnt work unless shaken my drill doesnt work unless i shake it,i have replaced the brushes,but no change It sounds like a bad cord, or a loose electrical connection inside the handle, or the ...
...cordless drill is not charging. The light doesn't come on when I put the battery pack in the charger. Is this a problem with the battery or the charger?? try wiggling the battery around and see if a ...
...cordless drill is not charging. The light doesn't come on when I put the battery pack in the charger. Is this a problem with the battery or the charger?? sounds like my charger, not making good ...
Question about DC920KA Heavy Duty Xrp 18V Cordless Drill/Driver
i have to bang the bottom of the battery yo make the drill work could be loose prongs on batt. or drill,take off battery and see if prongs wiggle with your finger.had problem before was trigger though
Question about Makita Bhp452 18v Cordless 1/2" Hammer Drill Bare Tool
...cordless drill barely turns and is smoking If it's pulling hard then gets hot enough to smoke your problem could be in either the motor or transmission. If you can, seperate the motor from ...
Question about Makita Bhp452 18v Cordless 1/2" Hammer Drill Bare Tool
...cordless drill corded screw gun something with a clutch5/32 or a 1/4" self tapping hex head screw by 3/4" longa driver for #12 hex head(I can't remember if it's 3/16", or 1/4" or 1/4" or 5/16"1/4"90 ...
Question about Makita Bhp452 18v Cordless 1/2" Hammer Drill Bare Tool
...cordless drill Hi. When the 3 pins are opened all the way there is a phoenix type screw in the centre of the chick.(inside where the drillbit comes) There you can hold the chuck with hand or bench ...
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions