...relearn security or crank sensor without dealers scanner?I have tried both computer from 98 and 2000 s-10's.Both vehicles mran before swap! i seen in gm manual when you exchange crank sensor .it have ...
...crank relearn this must be done with a good scan tool such as snap on modis/solus OTC genisis or GM tech 2 a cheap scan tool CAN NOT preform this function. A crank relearn will renew ...
...relearn-theft-deterrent-module.html---------theft deterrent module Relearning? http://howtobyme.blogspot.com/2012/01/buick-theft-deterrent-module-relearning.html--------Engine will not crank ...
...Crank: check engine Key down to ON: battery + check engine It's an intermittent problem, and when it does happen, performing the 10-minute passlock relearn procedure occasionally works (50%). When ...
...relearn crank position and passlock relearn. at least. And the crank relearn is a dealership(unless you have a really hi-end repair shop around) Still expensive. ECM's rarely fail,I would suspect ...
Question about 2006 HHR
...relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK. Important: The vehicle learns the password on the next ignition switch transition from ...
Question about 2006 HHR
...done with a scan tool from a shop or dealership. In most cases, the crank sensor has no relearn procedure on GM/OLDs products. Instrall a new sensor and the PCM will recognize it and start the ...
Question about 2006 Sentra 2.5
...are plug and play. They are controlled by the PCM. There is a crank sensor relearn, but it takes a scanner to do this. also, if you didn't clear the codes, the PCM will still think it has
...crank relearn the cam relearn your ejection here in all kinds of other stuff you have to relearn for that motor. I believe is if it's a Duramax you have to prime the fuel injector rails and heat up ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions