Question about 2005 PT Cruiser
crank sensor located on 2005 chrysler pt cruiser? Where is the crank sensor located on 2005 chrysler pt cruiser? the crank sensor is located on back right side of engine by were the trans. bolts up.is
Crank sensor and camshaft sensor Will someone please tell me where the crank sensor and the camshaft sensors are located?1998 Chrysler Sebring 2.5 v6 The crank sensor is in the top of bell housing of ...
...crank/cam sensor faults 2004 PT Cruiser no turbo. Engine died at hwy speed crank/cam sensor faults will not start o1 cruiser spit and sputter go down rd put cam sensor and crank shaft sensor on ...
...crank sensor can shut things down. What do I need to do next? If you remove the fuel line and crank the engine and get fuel then you could be assured that the crank sensor works but if there is no ...
...cam posostion sensor ? p1391 is intermitant loss of signal from crank sensor and cam sensor--change sensors!! change cam sensor first. good luck!! then try it, if still same way. change crank
sensor? or Crank sensor? I know that the generic definition of DTC P0340 is "No cam signal at PCM" however, a crank sensor can also be the cause of this code. A cam sensor normally will not cause a no
car till it wont start up again; unplug the crank position sensor and count to 5 then plug it back in. If it starts then its the crank sensor.(just a quick way to test it and get you home or to a shop
...Fuel injectors? ECM? If you do not have spark your crank sensor will need replaced it controls spark, a cam sensor controls fuel trim. The crank sensor is located on the transmission bell
Question about 2005 PT Cruiser
...crank sensor code for crank sensor came on replaced sensor but light came back on with crank sensor code The check engine light is still on because the fault identified by the computer was not caused ...
Question about 2005 PT Cruiser
...crank sensor, getting power to injectors (noid light), have an RPM reading on scanner, also have fuel pressure. cranks but will not fire due to no ignition. thanks Make sure the ring that goes around ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions