Questions & Answers for: Buick LeSabre crank sensor

Question about Buick LeSabre

1 Answer

...crank sensor is located at the crank pulley it sits inside and creates a magnetic field and produces a low ac voltage 5 ac volts or less module then converts it to a squar wave to fire injectors and ...

Ad

...crankshaft sensor up? if not the sensor could have been damaged and the harmonic balance ,some models show a cam sensor ,check that,are u sure its not fuel related? No my crank sensor goes on one ...

Ad

...crank sensor. It started up fine and ran for over 20 miles then just shut off. I checked the fuel and it seemed okay, and I was not getting fire. The car sat for a few minutes and started again and ...

...crank sensor will sometimes fail when the car gets hot. I have ran some of these cars before until they cut off. I sprayed come water on the crank sensor and the car restarted. Replaced crank sensor ...

...crank sensor, it sends signals to engine module to give spark, make sure security system light is not on, the crank sensor sits on the main crank pulley, you may have to remove pulley to replace it, ...

...cam sensor, crank sensor, and ignition control module. next time it won't run after it heats up, spray or pour water in crank sensor and see if it will start. I have seen new crank sensors go

Question about 1993 LeSabre

1 Answer

...crank sensor??? Hello: Yes, The crank sensor is behind the crank shaft pulley. Check the wiring where it leaves the sensor and goes up near the alternator. On this year car its possible a small rock ...

Question about 1997 LeSabre

1 Answer

...sensor car crank and runs good then when i let is run in one place it start acting like its over flood with gas but its not someone said its the crank sensor cause when i try to start it back up it ...

Question about 2001 LeSabre

1 Answer

...crank sensor is located behind the crank pulley on the 3.8 liter. The crank pulley must first be removed. A 15/16" socket, three very long 8 x 1.0 bolts (pretty sure that is the size, some large ...

Question about 1995 LeSabre

1 Answer

...crank position sensor and second is the mass air flow sensor followed by the fuel pump or relay. you need to first find out if your fuel pump output is 45psi i it has good fuel pressure then i ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

1998 Buick LeSabre
1998 Buick LeSabre

897 Questions

Manuals & User Guides

Loading...