Questions & Answers for: Chrysler PT Cruiser crank sensor

crank sensor located on 2005 chrysler pt cruiser? Where is the crank sensor located on 2005 chrysler pt cruiser? the crank sensor is located on back right side of engine by were the trans. bolts up.is

...crank sensor located on a 1995 Jeep Grand Cherokee Larado 5.2 liter engine front of the engine near the crank pulley on the crankshaft pulley inside the pulley its a little cylinder which is your ...

...crank/cam sensor faults 2004 PT Cruiser no turbo. Engine died at hwy speed crank/cam sensor faults will not start o1 cruiser spit and sputter go down rd put cam sensor and crank shaft sensor on ...

where is the crank sensor located crank sensor is located near the crank pulley. It should have two wires that go to it.

CRANK SENSOR Use the fluke meter. Unplug the sensor, and backprobe the connector. Theres 3 slots, you want A and B on the connector going TO the sensor- not TO the engine. Normal resistance is 200ohms

...to control the spark and firing of the plugs in the correct sequence and at the correct time....If the scan tool said the crank sensor I'd think that's the fault and stick to that.... Regards ...

car till it wont start up again; unplug the crank position sensor and count to 5 then plug it back in. If it starts then its the crank sensor.(just a quick way to test it and get you home or to a shop

...not start If it turns over (cranks) but does not start, it is almost surly a bad crank sensor. Check to see if your tachometer moves when cranking the engine-if it does not, install a crank

...sensor crank sensor wires plugs and coil still getting 1391 code and from 0 mph to 20 mph car skips and revs up any ideas? pt cruiser has code 1391. i have changed crank sensor cam sensor plugs wires ...

...crank sensor code for crank sensor came on replaced sensor but light came back on with crank sensor code The check engine light is still on because the fault identified by the computer was not caused ...