Questions & Answers for: Kia Sedona crank sensor

...crank sensor and another sensor still nothing. crank sensor is bad disconnect the battery and leave it for a 10 to 15 mins then it will reset itself then reconnect the battery and it should start KIA ...

...3.5? I have a no start condition. No spark. Crank sensor? you got to scan for codes first ,crank the engine first ,don"t put key in off position (that may erase CPS sensor codes )and scan it

Crank shaft position sensor probable causes Crank shaft defective, Check connector and wiring to sensor, or check trigger wheel for damage Code P0340 reads Cam Shaft sensor Cam shaft sensor defective,

where is the crank shaft sensor located on a 2003 kia sedona? Hi, the crank sensor is located behind the timing belt cover. It is right above the crank shaft timing gear.

...crank position sensor on a kia sodona 2005 and fix it? where to find it and fix it? To locate the crankshaft position sensor you will need to remove the timing belt cover.The sensor is located ...

...crank sensor,no start there is no fire to coil.getting 12 volts. replaced crank sensor again, redone timming belt same thing???? It might be this sensor I can't think of the name of it but it is ...

...cover. It sets by the timing belt, so if you have a loose timing belt it could hit the crank sensor or throw up pieces of itself onto the crank sensor. A bad crank sensor can mimic a fuel pump

Replacing crank sensor in kia sedona 2005 crank se it is behind the crankshaft pulley. the timing belt needs to be removed. would recommend doing the camshaft sensor as well as the timing belt.

...CRANK SENSOR replacing A 2006 CRANK SENSOR. HAVE REMOVED COVER MUST I REMOVE PULLEY TO REPLACE SENSOR No. Disconnect neg battery terminal/remove connector from sensor/remove bolt that holds ...

...have the P0355 crank shaft sensor error code. I am wondering if this is the true problem or a wireing problem. Any info would be great. yes and do not drive the van until u change that crank