Questions & Answers for: Mitsubishi Eclipse crank sensor

...crank sensor, cam sensor, or e.c.u.? And...how do I check these parts and in what sequence? The crank and cam sensors I can't even locate. Thank you for any help you can give me in a solution! John ...

wont start has power and cranks with no spark Have the codes checked. Could be a bad crank sensor, NOx sensor, or camshaft sensor.

...crank sensor replaced. still no start or spark. On this model engine, the power to the coil pack is delivered directly from the power transistors located inside the PCM. If you are not getting the ...

...crank sensor and ecu 0n 1992 eclipse 1.8L . Cranks has no spark. connect a test light to the plug on the ignition coil with it disconnected and crank the engine. if the light flashes the crank sensor ...

...remove lower timing belt cover. The Crank sensor is located behind the crank shaft pulley!! I highly recommend having this done by a certified tech, requires special tools. Hopefully this

...Crank sensor is dead get a new one have it replaced/ Cam sensor controls gas / Crank sensor controls Spark Delinquintd: I have the same problem but I have a manual tranny. Engine ran on old car then ...

...crank sensor changed three times because it keeps blowing the person working on my car said i needed a crank sensor gear do you know 2.0 SOHC are you using a factory sensor?i would check the end play ...

and coil pack, replaced ecu (pcm). Turns over just no sprak obviously because there is no power to crank sensor The crank sensor gets power from the MFI relay just like the injectors and cam sensor do

crank sensor is what the computer fires off of. You need to figure out what your car does not have. If it has no spark look to the coils and see if they are getting the signal to fire the plugs. If so

...crank sensor. Before crank sensor went bad car ran great and was daily driver after I changed crank sensor it runs and drives great as long as it is on flat ground but has no power to go up hill. How ...