Questions & Answers for: Plymouth Neon crank sensor

Question about 1996 Neon

96 neon been shutting off at random then will restart

...sensor, crank sensor code read 11 and 12 bat. disconnect and intermitent loss of signa/cam/crank shaft sensors. when replaced cam sensor the codes only read 11 and then it still shut off... no fire.. ...

Question about 2001 Neon

1 Answer

I need to know where the crank sensor is located

...where the crank sensor is located behind the harmonic balancer. THis is the main drive pulley for all your belts. It will be on the crank shaft but the opposite end of the motor from the ...

Question about 1998 Neon

2 Answers

I just finished replacing the head gasket on my

crank the engine. If the test light momentarily flashes, the camshaft position sensor is shorted and must be replaced. If the light did not flash when the engine was cranked, the cause of the no-start

Question about 1999 Neon

1 Answer

Car doesnt rev up

...crank sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be ...

Question about 1999 Neon

1 Answer

We replaced the Water pump

...so whats left is ignition module, crank sensor, knock sensor, cam sensor, or the timing was not was not set properly when putting it back together. Any one of those would create a no spark

Question about 1999 Neon

1 Answer

I have a 96 Plymoth

sensor, a crank sensor, or a new computer. I know the computer is good... The code is reading a 5 but i dont have a Hyanes manual for the car. If any one could help me out I would really appreciate it

Question about 1997 Neon

1 Answer

Looking for location of crank

sensor The crank sensor is on the back of the engine block right above the oil pan. it is near the center of the engine in regards to right to left. it is bolted down with a 10mm or 8mm bolt. you will

Question about 1997 Neon

1 Answer

I have a 1997 plymoth neon with a single overhead cam, it will not start and has no spark, i have replaced the coil pack, crank sensor, cam sensor. some of the gauges go crazy when the car is on. the

crank sensor, cam sensor. some of the gauges go crazy when the car is on. the scanner will not read the codes, it says that it has no power . can you help me figure this problem out? Are getting power

Question about 1995 Neon

1 Answer

I have a 1995 dodge neon cranks but will not start. any ideas. i have replaced the crank and cam shaft postion sensors. replaced the starter. fuel pump is fine. injectors are pulsating. car occasional

i have a 1995 dodge neon cranks but will not start. any ideas. i have replaced the crank and cam shaft postion sensors. replaced the starter. fuel pump is fine. injectors are pulsating. car ...

Question about 1997 Neon

1 Answer

97 plymoth neon crank sensor

...crank sensor Car is not getting any spark to first and fourth cylinder If there is spark to cylinders 2 & 3 than it is not the cranks sensor. Cylinder 1 & 4 are on the same coil and cylinders 2 & 3 ...