...crank shaft sensor is located just above the front pulley at the front of the engine and is held in place be a 5mm hex bolt, undo this and remove the sensor then you will need to follow the wire that ...
...me back.Please help!!! Hi, you must take off the crank shaft pully to access the water pump use # 13 mm socket or Torx socket (not sure wich one) to take off the crank shaft pulley bolts. Good
...crank those security bolts right out. Don't forget to take careful note of the positions and orientations of the two bushings between the steering wheel and the bearing in the lock housing. Put them ...
...crank shaft pulley. after removing that belt you will have to reach up into the motor between the Idler pulley and the power steering pump, it is really hidden well but if you reach up into the motor ...
Usually answered in minutes!
789 Questions
796 Questions
708 Questions
690 Questions
600 Questions