...crank shaft sensor and ignition control module? ECM would be the next part. Check the number on it . If it has the number 1228253 replace it anyway because they give a cutting off problem. Clean ...
...crank shaft?) on my 1991 buick parkavenue is clanking why? how to fix?-installed new water pump,new tension pulley for serpentine belt and new used airconditioner pump but still noise there Because ...
...end wrench socket wrench and sockets dont forget to unhook the battery theres is three bolts just make sure you line starter back up to crank shaft and dont over tighen bolts its aluminum good ...
...shaft so that you can put it all back together right when you're done. Remove the dust cover and other incidental parts to expose the turn signal switch. By turning the signal switch one way, you ...
...crank shaft. It has two parts, an inner and an outer that are joined together with a rubber isolator. Over time the rubber breaks down and the inner part part of the puller will start to rotate ...
...crank shaft, attached to the block with two upper and one lower horizontaly mounted studs. The motor mount is also attched to a frame mount with two vertical studs extending up about 2 1/2 inches. To ...
the crank pulley. Use a gear puller the remove the pulley. If you don't have an impact gun, you have to remove the starter . So you can hold the flywheel/crank shaft from moving as you remove the bolt
Usually answered in minutes!
690 Questions
585 Questions
537 Questions
482 Questions
474 Questions