Questions & Answers for: crank shaft stuck

...crank shaft meet the chute there is a connection which is held in place bt a cotter pin or (on some models) a small screw. These can loosen and fall off causing the chute to stay in one position when ...

Ad

location of crank case sensor on a 97 towncar It doesn't have a crank case senor. Do you mean crank shaft position sensor? It is stuck in the block between the block and the A/C compressor.

Ad

Question about EvinrudeJohnson Outboard Shop Manual 48 235 HP

1 Answer

...crank shaft when the union was unscrewed.Now if that didn't work, you can cut the drive shaft off the engine at the crand shaft and drill a hole thru the stuck part. Then tap a thread into the ...

Question about 2002 XR 200

1 Answer

...crank back hi, sounds to me like the kickstart stop mechanisum has become loose or damaged, does it get stuck at the top of the travel, or the bottom, also you could have damage to the shaft itsellf ...

Question about 2002 XR 200

2 Answers

crank shaft and drill a 1/4" hole thru the shaft in line with the crank and tap the hole and screw a bolt into the shaft piece till you walk it out on the bolt threads. Hope you have a simple cure and

...and stripped crank teeth I may buy a 97' heritage but the after market starter stuck an stripped the crank shaft gear. Is this a difficult repair or costly? Hi Rich, $400-$500. Have nice ...

...crank shaft bearing. When they go they quite often knacker the piston and cylinder too as it can put them off square. Remove cylinder and the problem will be easy to locate as you can see the ...

...crank and cam shaft? it sounds like u have something stuck in the engine ,u should be able to turn the shaft manually.so tear it back down and look for something in there or something stuck.dont try ...

...shaft next to block and cranked engine. No spark probably not the distributor as there are at least three items that will not give you spark immobiliser not operational, cam/crank position sensors, ...

...crank shaft on my Volvo s40 2000 1.9 liter it gets stuck when turning a revolution ? what does that mean is wrong trying to turn crank to top dead center it can be only mechanical obstruction - and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plumbing Experts

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66835 Answers

Are you a Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...