Questions & Answers for: crankshaft sensor of disco 2

...Disco II 2003. Ice Alarm System Could be a problem with the sensor, as their is a few sensors, door(s), hood, depending on he car a few others. One of the sensors could be going bad and is super ...

crankshaft position sensor landrover disco I have a series 2 v8, its cutting out when driving, when idling, have checked for spark..it didn't have any then when I came back after half an hour it ...

...sensor and the crankshaft pulley The reading should be 520?580 ohms at 68°F (20°C). If not as specified, replace the sensor. Measure the air gap of the sensor between the crankshaft pulley ...

...IT IS A FAULTY CRANKSHAFT SENSOR. PART NUMBER ERR7352 IF ITS MANUAL TRANSMISSION AND ERR7354 IF ITS AUTOMATIC TRANSMISSION. wHEN THIS SENSOR PLAYS UP, IT WILL NOT FLAG A FAULT CODE. HOPE THAT DOES ...

...Sensor crankshaft position SUZUKI AERIO SX AWD 2.3L 2005.How to replace under the scheme ? Welcome to FixYa.com Crankshaft Position (CKP) Sensor Removal and Installation Removal 1. Remove engine with ...

...Sensor A) # P0017 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor B) # P0018 Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A) # P0019 Crankshaft Position - ...

...Crankshaft Position Sensor -Circuit Malfunction P0336 Crankshaft Position Sensor -Range/Performance P0337 Crankshaft Position Sensor -Low Input P0338 Crankshaft Position Sensor -High Input P0339 ...

...sensor A)). Both crankshaft position sensors are located in the back of the engine just above the oil filter adapter. To access both CKP sensors, jack up vehicle on the passenger side, remove the oil ...

...disco 2 year 2000. thanks v8 iv just bought one thanks Good job I know what a 'disco' is. Mother worked for Land Rover :>) Land Rover Discovery 2 Buyers Guide - Coventry West ...

...crankshaft sensor, maybe 2 camshaft sensors, one for each bank, and there are two O2 sensors for each bank. ...