data port settings trying to connect my Krazer1 Cell to my HP/Windonw's Vista. The phone works fine on my regular PC. Error comes up: data port?? Is this the setting that is the problem? Hi Rthorntor,
Question about Computers & Internet
...port and transfer data b/w them my project is to transfer data b/w two PCs and the outlook will be made in VISUAL BASICS.data can be chats mails etc.the mode of connecting PC is using Comm ...
Question about Vertex Radio Communications
port is usable for 9600 bps DATA communications, because the filter and limiter are not engaged in the Audio line. Pin 14: DC OUT [13.4 V/5 V DC Output] Switched 13.8V output for supplying power to an
Question about Latitude D600 Notebook
...port will not send any data to attached device. Anything I can do to get the serial port to operate correctly? boot to the bios (system setup).. locate serial port there and make sure it is turned on ...
Question about Latitude D600 Notebook
...port does transfer data to the computer though, this is the reason why it is ackowledged as an external hard drive when you plug it this way. The best is to plug both, this will give you the ...
Question about Latitude D600 Notebook
...port and power up the data projector first and then the laptop. If you had power up the laptop first then you can toggle the video between the LCD screen and the video port by pressing the Fn key and ...
...data cable to the I/O port of each unit. The cable will fit tightly in the I/O port and snap into place. If silver from the cable is visible, the cable is not properly connected. ? Access the Link ...
Question about Batch Barcode Scanner P360/460 Memory Scanner
...port to receive the data from the scanner. 4. We scanned some barcodes using P-360 scanner, hit Function F1 on P-360 to transmit the data, the status message appeared as ?Connect unit to host? and ...
...port...if i send data 1 or 2gb data to pen drive.the starting data speed will be up to 8mb per second after some will the usb ejects and connect again in that time the data trans fer speed will be to ...
data to the port number that it was told to by the client. Since the Server has initiated the connection, a stateful firewall will not allow the data to be sent back though. (No client has created the
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions
