Questions & Answers for: GTCO digitizer

... the pen looks like the correct pen for a Summasketch III. If you need to order parts or replacment digitizer got to this page where you can order them: ...

Digitizer isn't working properly I am only able to use a certian portion of the digitizer. I've tried to mess with the control panel to change it so I could use the entire thing but it won't allow me.

Calcomp GTCO Roll upDigitizer I have a 30 X 36 roll up Iii digitizer and I can not get my computer to reconize it I downloaded the drivers and tblet works can Idenifey my digitizer but it will not ...

The GTCO digitizer roll up board was folded and now has a crease. The GTCO digitizer roll up board was folded and now only reads on half the surface . Is this repairable...? Ryan No, the lines in the ...

My digitizer works fine but the other day it just started "beeping" everytime I hit any key. It is driving me crazy. Tried shutting off the computer system sound but that doesn't help as the

Relocated digitizer and when set up it peeps with message running self test no digitizer Make sure the Digitizer is set to Superset Code S01, it may also be a bad cable,check all of the cables for ...

...software, currently working in reverse This could be a problem in Paydirt or the setup of the digitizer. The Roll-Up II and Roll-Up III digitizer would allow you to change the orientation from ...

...ESRI ARC Programs as far as I am aware use the Standard GTCO Tablet Works drivers. All GTCOCalcomp digitizers are or were level 1 supported by ESRI and the standard tabletworks driver will work just ...

NEED WIN 7 DRIVER FOR GTCO CalComp Drawing Board III Drivers for GTCO, GTCOCalcomp or Calcomp digitizers for Windows XP, 7 and 8 can be downloaded from this ...

How do I reset the digitizer? There are areas on the digitizer surface that do not work when I touch the pen on them, and others that do work. Will resetting the digitizer correct this problem? If so,