...shake it to re-distribute the toner. Tried that, but it did not help. Next most common cause was a dirty "charge wire". Have not been able to find any charge wire on this unit! Tried replacing the ...
Question about XV-Z2000 Multimedia Projector
...even put in a new bulb. Does anyone have any thoughts. Check the air filters. Sometimes if they are dirty, they will stop the airflow to the projector and it will not turn on because it keeps ...
Question about XV-Z2000 Multimedia Projector
Does the TOSHIBA TA8445K Vertical Deflection IC fails when the Deflection Yoke is Dirty? This article for Sharp television model 21V-W99 seems to support it: ...
Question about 56DR650 56" Rear Projection HDTV
i was told by a friend who has his own shop that the color wheel has to spein at a certain rpm....a dirty color wheel with dust in motor will cause it to run at lower rpm causing numerous problems..as
...causing the unit to shut off on high or low pressure. It could be low on charge or overcharged, dirty condenser or evaporator, bad thermostat or electrical component or wiring. Unless you are ...
Question about AR-5316 Advanced Digital Imager Copier
...no codes listed in service for operator/user problems. SC-101 Exposure lamp, lamp stabilizer board, dirty white plate, dirty optics, SBU board, CCD SC-103 Power problem SC-104 Exposure lamp problem, ...
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions