Questions & Answers for: distributor wont turn

Question about 1983 Ranger

2 Answers

...distributor wont turn!!! I have a 1987 ford ranger with a 1983 model 2.0L in it with a 1 barrel. One day i was on my way to work and it just died on me. I replaced the plugs, wires, ignition control ...

Ad

turn the car over and it cranks, but wont turn over...can any1 please give me an idea because im stumped try to spin the distributor till you can get it started then tighten down screw for distributor

Ad

...distributor wont turn and you will get the same results. take the distributor cap off and check and see if the rotor spins while someone is cranking the engine. if it doesnt turn your timing belt is ...

...wont start PLEASE HELP ME I NEED TO GET MY KIDS TO SCHOOL! Your problem sounds like the distributor, points and pig tail wire. I suggest you try changing the distributor / servicing the points and ...

...wont turn when motor is truning over do i have a bad dist. The prognosis I suspect is worse than bad distributor. I suspect your timing belt broke and is not turning camshaft which turns your ...

...distributor from the engine block now my car wont start what should i do? if it was not turned over with distributor out of engine, turn over engine by the bolt on damper pulley to tdc ( top dead ...

in the engine quite running going down road The timing belt is powered by the crankshaft, and the belt turns the camshaft, which turns the distributor. If the belt is broken, the distributor wont turn

...distributor, It wont start! Engine turns over and sounds like its firing, but It seems like its not getting fuel. Plugged it into a diagnostic and got NO CODE. All fuses are fine and fuel pump is ...

Question about 1986 Ranger 2WD

1 Answer

...wont start. there new plugs fuel filter & the carb has been rebuilt. Check for spark at the distributor if no spark check or replace coil pack. also check to see distributor is turning while engine ...

Question about 1998 S-10 Pickup

1 Answer

wont turn over has new coil and distributor you mean it cranks fine but wont fire? When you installed the distributor did you set it in exactly where it came out? like where the rotor was pointing and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...