Questions & Answers for: dodge vacuum pump

dodge neon? p1494 isnt for the purge solenoid it is for a mechanical switch failure detected in the leak detection pump. as long as the pump has vacuum going to it the likely cause is the pump itself.

dodge 4x4 is not working need to check the central axle disconnect (cad) to make sure the vacuum lines are still attached, and check the vacuum pump to make sure it is working when you select 4wd. cad

vacuum pump diagram 2002 ram my husband had his motor replaced in his 2002 dodge ram truck and since then the heater does not work right he believes the vacuum pump lines are not connected correctly ...

Dodge Ram 2500 with a Cummins Diesel. On the way home I could not engage the cruise control. I checked all the fuses but can't find the vacuum pump. So I can't tell if a hose is disconnected. The pump

...dodge 2500 diesel, oil leak in front of power stearing pump shaft, what is the power stearing pump shaft run off of? The power steering pump is piggie backed to the vacuum pump. The seal in the back ...

dodge durango 4.7 fuel pressure flutters during idle IF FUEL FILTER HAS BEEN REPLACED.FUEL PRESSURE REGULATOR IS GOING BAD OR NOT GETTING VACUUM.CHECK VACUUM LINE GOING TO FUEL PRESSURE REGULATOR.MAKE

...dodge dakota front diff will not lock in Remove the two vacuum hoses on front axle Apply vacuum with a hand held pump and check for the vacuum actuator, pulling in the right front axle. If okey,go ...

...vacuum pump in the Dodge W150-350 Cummins Diesel is integral with the power steering pump on the driver's side of the engine. remove it as one unit from the accessory drive unit. Then you have to ...

...dodge stratus duel over head cams 2.4 liter, the water pump is ran off the timing belt got the water pump on lined the timing marks up, but it idles rough runs good on the highway Check for vacuum ...

...dodge dakot if I pump the brakes why it’s idling should the truck rev up as I’m pumping them Sounds like brake booster is bad.check for vacuum leak.remove vacuum hose and cap off then start engine. ...