...turn it off. Any ideas (that doesn't involve smashing it, like my husband suggests)? Noodles, it sounds like the float valve inside the water reservoir is stuck in the down position. Turn the ...
Question about 31913 Progressive Direct Drive Bagged Upright Vacuum
...doesn't turn. Little red reset pin doesn't move. Something is jammed in it or the belt is bad.Turn it upside down.You will see 4-6 screws.Remove the screws and the plate they are holding.Now ...
Question about 31913 Progressive Direct Drive Bagged Upright Vacuum
...turn the water back on. Now, this doesn't work. I assume the mixing valve solenoids aren't working. Is there a repair or do I need to replace the mixing valve? I would take the mixing valve ...
Question about 31913 Progressive Direct Drive Bagged Upright Vacuum
...a higher frequency noise when turned on.Now it doesn't spin or work. It just buzzes.After trying to turn it back on 3-4 times it just clicks. It doesn't work at all. Check for a broken
...doesn't turn, the agitator does. What is next? My washer was doing the same thing. I had a magic marker on the bottom of the plastic tub below the inner tub. The agitation cam could not release ...
Question about 3.2 cu. ft. Plus Top Load Washer
...doesn't catch to turn the corkscrew part. Please help! I can't afford to hire the appliance guy to come repair it! Hello, That sounds as if the parts called the agitator dogs are worn out and ...
Question about 3.2 cu. ft. Plus Top Load Washer
I have a Kenmore range top stove. One of the burners doesn't heat. I replaced the burner coil, the plug that it goes into, and the 5 prong switch that turns the burner off and on. I still don't get po
...doesn't turn freely--if it's frozen or stiff--replace it. It pumps, but the water returns If the water that pumps out of the machine goes back into the machine after the spin cycle, your ...
...over see if that helps or bobbin case is not inserted correctly 2. Lint has collected in the bobbin holder 3. The bobbin is damaged & doesn’t turn smoothly 4. Lower thread tension is two ...
Question about HE2 Plus Front Load Washer
...turn the gas on to low. If the burner doesn`t light, the problem is the gas supply to the burner. Next, lift the top cover and put the prop rod in the hole in the cover to support it. Hold a match to ...
Usually answered in minutes!
30 Questions
13 Questions
0 Questions
1 Questions
11 Questions