Questions & Answers for: GMC door actuator

...door actuator? I have the same problem. The rear door actuator is bad. you have to remove the interior cover and pull on the 2 cables that release the hatch door catch. replace the lock actuator ...

...actuator it was causing the door lock rod (the rod from the keyed cylinder lock to the actuator) was on a bind......the solution I came up with is adding an additional 3/4" spacer between the factory ...

door lock actuator was bad, while i was replacing the actuator i noticed that the rod that goes from the keyed cylinder lock to the actuator was on enough of a bind that it was near impossible to lock

...actuator door, and flushed heater core still no heat. Automatic ac when on heat does not blow out front vents at all and when switched to manual heat cold air blows out. Is there a heat sensor and ...

...door actuator is. It's usually right of center under the dash. Look under there and see if you can see anything trying to move when you change the temperature setting. Also, if you hear a clicking ...

...door actuator is stuck or burnt out or actuator door is jamed locate and place remove motor actuator check if blend door move freely if not repair or disloged foring object (pencil pen---comb---etc) ...

little air or a lot of air? Sometimes junk does get into the air box and will stop the door from repositioning correctly. You can try that. Yes, the blending door is directly connected to the actuator

...door actuator in a 2003 savanna GMC van? http://www.bing.com/images/search?q=air+blend+door+actuator+in+a+2003+savanna+GMC+van%3f&FORM=HDRSC2 ...

...door actuator through the mode door control circuit. Zero volts drives the actuator in one direction while 5-volts moves the actuator in the opposite direction. When the actuator receives 2.5 volts, ...

...door actuator is bad , this actuator controls where the air comes out , vent , defrost , floor etc...... May have video on youtube . MODE DOOR ACTUATOR REPLACEMENT 1999 GMC Denali mode door or ...